Blocked nozzle I

1. Blocked Nozzle

I. Needle cleaning

With little bit of luck, the unblocking of nozzle could be a quick a easily done. Start by removing of the filament. Then heat up the nozzle throug your control panel (if it has the function) to the melting point of the stuck filament. Or you can connect the printer to compatible control software and heat up the nozzle. For the PLA set up the temperature to 220 C. Once the nozzle heat up at right temperature, use a thin pin or special needle for that use to clear the hole of the nozzle (attention: to not burn your fingers).